XY-WJ01 với kỹ thuật số LED hiển thị thời gian kép chu kỳ Thời gian chuyển mạch Mô-đun Rơle tác dụng chậm

Time range: 0.01 sec ~ 9999 min Please read the user instructions carefully before using. Product highlights: Display with two LCD columns, can display parameters directly; Trigger mode: high and low level, switch quantity. Meets most requirements. Power supply: 6 ~ 30V. Parameters can be modified via UART. Stop button to provide emergency stop function. 5 minutes without any operation into low power state. Any wake-up action.OP/CL/LOP params can be modified individually All parameters are saved automatically by power.Introduction of working mode (P1 ~ P7)P0: after the signal is triggered, relay flow in OP time then disconnect; In the OP time, the signal is invalid. P1: after the signal is triggered, the relay conducts in the OP time and then disconnects; In the OP time, the signal triggers a new timer. P2: after the signal is triggered, the relay conduction in the OP time then disconnects; In the OP time, the signal trigger resets the timer, the relay is cut off and the time is stopped. P3: after the signal is triggered, the relay cuts off the CL time, and then the relay conducts. P4: after the signal is triggered, the OP time relay conducts, and then the relay cuts off the CL time, and then the action loop above, giving the signal again in the loop, the relay disconnects, stops the timer; And the number of cycles (LOP) can be set; The end of the cycle, make sure the relay is disconnected; P5: after the signal is triggered, the relay cuts off the CL time, and then the relay flow of the OP time, and then the above action loop, gives the signal again in the loop, the relay flow, stop the timer; And the number of cycles (LOP) can be set; The end of the cycle, save the relay flow; P6: no trigger signal after power, after the flow of the relay OP time, the relay decides CL time, and then the above action loop, invalid signal in the loop, the number of cycles (LOP) can be set; The end of the cycle, continue to disconnect the relay; P7: no trigger signal after the power, after the relay cut off time CL, relay conduction time OP, and then the above action loop, invalid signal in the loop, the number of cycles (LOP) can be set; The end of the cycle, save relay conduction; P8: signal holding function: signal is maintained, time is cleared, and relay conduction; When the signal is lost, the relay disconnects after OP time; During the time, there are other signals and the time is cleared; P9: signal holding function: the signal is maintained, the time is cleared, and the relay is disconnected; When the signal is lost, the relay conducts after CL time; During the time, there are other signals and the time is cleared; (P0 ~ P7) mode, press the short pause button, start the time if the system is not timed; If the system is already timed, the system stops using the timer, the relay is disconnected, flashing "out" to show the warning; P8/P9 mode, the pause button as the trigger signal in the running interface, short/long press fail;