Thanh Đèn LED PIR Dùng Pin 1M 2M 3M Đèn Ngủ Cảm Biến Chuyển Động, Tủ Cầu Thang Có Cổng USB Tủ Quần Áo Nhà Bếp Đèn Mọi Nơi

product specification
Please choose the correct type before ordering
Technical data (LED light bar):
LED type: 2835SMD
Number of leds: 60 leds / M
Length: 1M / 2M / 3M / 4M / 5M
Voltage: DC5V
Light color: white / warm white
Color temperature: white (6000k-6500K); Warm white (2700K-3500K)
Waterproof: IP20
Specifications: motion sensor / no motion sensor
AAA battery not included
Induction distance: 2m-5m
Light control: 2 modes.
Mode 1: day and night
Mode 2: night
Operating mode: "OP" and "PIR"
When the button is pressed, the red light glows and the LED light bar will always be on. When the button is pressed again, the red light will turn off which will be "PIR" mode.

Use the introduction:
The inductive battery pack is divided into day (solar) and night (lunar) modes. Day mode means it can also work during the day; Night mode means it can work at night.
Adjust the time (time) knob to change the induction lighting time, which can be set from 15 seconds to 5 minutes.
The button on the front of the fuselage is always on. When the button turns red, it is always on. Always on mode can be used in both day and night modes
① When the switch button on the side of the hull is set to the sun, press the button always on, the light is always on and turn off the button always on, then it enters the day mode. During this time, people are in the light detection range and the light is on; Leaving the sensor range, the light will go out after a while.
② When the switch button on the side of the hull is selected to the moon, press the button always on, the light is always on and turn off the button always on, then it enters the night detection mode. If the surrounding light is strong, people enter the light sensing the range light is not bright. When the environment is relatively dim, people fall into the light sensing range and the light is on; After leaving, the light is dim after a while.