Mô Đun Hẹn Giờ Kỹ Thuật Số DC 12V

1: Product model: YYC-2S 24 common functions, to meet more application needs; can control solenoid valves, pumps, motors, lights, etc. 2: Input voltage: DC 12V optional 3: Output power: can control DC or AC load within 10A 4: Time range: 0.01 seconds to 999 minutes adjustable at any time 5: Description of the wiring port: (1) DC+: input DC power supply positive (2) DC-: input DC power supply negative (3)IN+: positive input terminal (4) IN-: signal input terminal (5) NO: relay normally open interface, the relay is suspended before the suction, after the suction and short circuit with COM (6) COM: relay common interface (7) NC: The relay normally closes the interface, and the relay is shorted to COM before the suction is closed. 1: Function list: P-11: Jog P-12: Self-locking P-13: Give signal, the relay will stop automatically for A seconds; the trigger will be invalid during the delay. P-14: Give signal, relay will stop automatically for A seconds; trigger re-time during delay P-15: Give signal, relay is automatically stopped for A seconds; trigger timing is triggered during delay P-16: Give signal, relay will stop automatically for A seconds; trigger reset during delay P-17: Give signal, relay is closed, input signal is disconnected, output is off after A seconds P-18: After power-on, the relay will immediately pull in, after a delay of A seconds, the power will be turned off; P-21: Disconnect the signal relay, after a delay of A seconds, the relay pulls in P-22: Give signal, after more than A seconds, the relay pulls in, the signal disappears, the relay stops. P-23: After the signal disappears for more than A seconds, the relay is closed, there is a signal, and the relay stops. P-24: There is a signal. After more than A seconds, the relay is closed. When the signal disappears for more than A seconds, the relay stops. P-25: There is a signal after more than A seconds, the relay is closed, and after a signal exceeds A seconds, the relay stops. P-26: There is a signal. The relay stops after A seconds of suction, and the signal disappears. The relay stops again after A seconds. P-27: The pulse signal is detected and the relay is closed; if there is no pulse signal, the relay delays for A seconds; P-28: After power-on, after a delay of A seconds, the relay pulls in until the power is turned off. P-31: After power-on, the relay pulls in for A seconds, disconnects B seconds, infinite loop; power-off stops P-32: signal, start P-31 and so on...... 2: Button setting instructions: The power-on display “————” means to enter the standby state; Press K1 for the first time (more than 1 second is required to prevent false triggering) Screen display: P -11: K2 adjusts the main mode, K3 and K4 adjustment functions Package: 1 x DC 12V LED Display Digital Automation Cycle Delay Timer Relay Switch Module