Khóa Sao Chép Sao Chép Điều Khiển Từ Xa 4 Phím Không Dây 433 MHz Khóa Sao Chép Cửa Nhà Để Xe

Instructions:

1. Clear code: two fingers simultaneously holding the key lock and the key lock; The fast LED light flashes 3 times in about 2 seconds; let one finger go (the other hand can't let go), and then use the loose finger to quickly three -click on the loose button until the LED light flashes quickly; Both fingers can release; Then press any one remote control key; when the LED light is off, it means a clear code is successful (four keys are all blank); If after you press any remote control button, the light is still active, it indicates that the original code was not successfully cleared. You need to clear it again, and only successfully clean up the code can cloning be successful. You can repeatedly clean and clone the code.

2. Copy: the left hand takes the original remote control, the right hand takes the remote control of our clone and keeps the two remote controls as close as possible; Press the first key of two remote controls at the same time; in about 2 seconds, the LED light will flash fast 2 times; After a second, the Indicator light keeps flashing and releases your finger; And then press the key after a successful study, the light goes on, which means that the first key code on the original remote control has been copied to another remote control; The same method can be used next on the second key, Third key ... If the copy is successful, the remote control function is the same as the original matching remote control.

3. Restore: when you accidentally clear the remote control code copy, you can press the remote control copy two down keys, the LED light will flash quickly, leave after pressing any key, long light, this indicates that the code for the remote control is restored. Before using our copy remote control, please be sure to remove the existing code from the remote control.

How to deal with situations where some keys can control, the rest can not control

You can use explicit and restore operations, specific operations are as follows:

1. Clear code;

2. After the clearing code, copy the unsuccessful key again, and there is no need to copy another button;

3. Clear the code again;

4. Retrieve the code; Currently, the original keys that were not successfully copied are now protected by the new code, and the original keys that were successfully copied are now retained. If there is no copy after the second copy of the key, repeat the above steps again and again until all the keys are successfully copied.

Features:

Better range, more durable and long lasting battery life.

With LED emitter & low battery indicator, for visual feedback and working mode indication.

Equipped with buckle for easy carrying.

Application: vehicle center locking system, garage door, electronic door, car sunroof, heating system, etc.

Remote control only, demo of other accessories in pictures not included!

Tip:

1. Select the remote control prerequisites: the original remote control function is normal, the remote control chip is the same or compatible, the operating frequency of the remote control is the same.

2. Remote control can only copy fixed code, learn chip code and part of a single chip remote control (can copy chip model see copyable chip type).

3. Two -way remote control, code rolling remote control, single -chip encryption program remote control can not be copied. Such as HCS200, HCS201, HCS300, HCS301 and so on.

4. Before copying the remote control, make sure the existing code on the remote control has been cleared and check that the code is cleared successfully. Otherwise, it cannot be copied.

5. Please make sure your remote control has enough power, the distance between the two remote controls is better.

6. If the copy distance is too close to the switch at different angles to be copied. Press and hold the button on the original remote control to send a completely normal signal, and then press the button on the remote control to make sure the function is fully copied.

Specifications:

Type: remote control
Channels: 4
Frequency: 433MHz
Rated voltage: 12V
Current value: 10mA

Package includes:

1 x 433Mhz Remote Control

No retail boxes will be included, but we will pack well before shipping.