DC5-80V WIFI Single Relay Module ESP-12F Development Board

ESP8266 ESP-WROOM-32 Development Board Test ESP32 Burning Fixture Tool for ESP-12S ESP-12E ESP-12F ESP-07 ESP-07S ESP-01 ESP-01S ESP-WROOM-32D ESP-WROOM-32U ESP32-SOLO-1

ESP32 Burning Fixture Tool

Suitable for firmware burning test of four modules: ESP-WROOM-32, ESP-WROOM-32D / ESP-WROOM-32U / ESP32-SOLO-1

Interface Description:

Lead out all IO ports, can be used as the smallest system development board or small batch burning fixture

Instructions for use:

1. Download the corresponding CP2102 serial chip driver according to the operating system and install it

2. Download the official FLASH download tool ESPFLASHDOWNLOADTOOL

3. Automatically download the firmware: press the module, insert the USB cable to supply power, cooperate with the FLASH download tool, configure the corresponding burning parameters, click START to download, the firmware burning will start, the downloader will automatically reset and make the module enter the burning mode

Manually download the firmware: Automatically download the firmware: press the module, insert the USB cable to power, open the burning software, configure the corresponding burning parameters, long press the burn button, then short press the reset button, click START to download, you can start the firmware Burn

ESP8266 Burning Fixture Tool

Suitable for ESP-12S ESP-12E ESP-12F ESP-07 ESP-07S

ESP-01 ESP-01S and other modules firmware burning test

Interface Description:

Lead out all IO ports, can be used as the smallest system development board or small batch burning fixture

Instructions for use:

1. Download the corresponding CP2102 serial chip driver according to the operating system and install it

2. Download the official FLASH download tool ESPFLASHDOWNLOADTOOL

3. Automatically download the firmware: press the module, insert the USB cable to supply power, cooperate with the FLASH download tool, configure the corresponding burning parameters, click START to download, the firmware burning will start, the downloader will automatically reset and make the module enter the burning mode

Manually download the firmware: Automatically download the firmware: press the module, insert the USB cable to power, open the burning software, configure the corresponding burning parameters, long press the

burn button, then short press the reset button, click START to download, you can start the firmware Burn