[100% Original] diymore Metal Servo Tester Simple Steering Gear Tester Metal Steering Gear Tester Model Aircraft Motor Test ESC Tester Third Gear Instruction DC4.8-6.0V

Product Name: Metal Servo Tester
Applicable configuration: steering gear motor ESC
Adjustment mode: manual, automatic, neutral
Output signal: 1.5ms±0.5ms
Input: DC4.8-6.0V
Output: ≤15mA(5.0)

Instructions:
Connect 3 sets of upper, middle and lower servos to test 3 servos at the same time.
When the power input terminal is connected to the power supply, the three blue lights will light up at the same time, and then the left light will light up. At this time, three modes can be selected through the mode. When the left light is on, it is the manual adjustment mode, and the potentiometer can be used directly. (and the adjustment knob) to control the rotation of the servo; then press the button, the middle light will be on, this is the center test; press the button again, the light on the right will be on, which is an automatic test, the servo will keep rotating, the card After death, rotate in the opposite direction, and cycle in turn. The connection method of the test ESC is the same as that of the steering gear. When testing the motor, you need to connect the ESC first. The methods are all according to the above steps.

Note: The positive and negative poles of the power supply cannot be reversed, if the reverse connection will burn the IC

Shipping list:
Servo Tester X1